PDA

View Full Version : Factory Five Alignment Specs


Purple Venom
03-31-2010, 07:06 PM
Here is what I am running now:
Ride Height of 4" front 4 1/4" in rear
Toe of 1/16"
Caster of +3*
Camber of -1/2

Some others on FFCobra are running:
Ride Height of 3.75" front 4" rear
Camber -1 Deg
Caster +4 Deg
Toe in -1/16

Ride height: 3.5'' (front), 4'' (rear)
Caster: 3*
Camber: -0.25*
Toe: 1/32 IN

Ok, I want a setup that isn't too hard to steer on the street, doesn't change lanes when I don't want it to, but good enough for non competition track days. Any thoughts to the setups above? Danny, if you are reading this, the top setup that I am running now is what is suggested by Factory Five and I guess let's check the existing to those specs

TOM KEISER
03-31-2010, 07:31 PM
Not sure what might work best for you but for reference I'm at

-1 Camber
+3 Caster
1/16 Total toe in
3.5" front
3.5" rear

Steve Fehr
03-31-2010, 08:24 PM
Tim:

Danny couldn't quite get my car to these specs, but these were the recommended ones.

Front
Total toe 0”
Camber -1.5 degrees
Caster +4 to 6 degrees

Rear
Total toe .06 to .12” in
Camber -0.75 degrees
Caster +3 to 6 degrees

Steve